|Made in China Extrusion blow molding machines|
1. Stable performance with advanced PLC.
2. Conveying preforms automatically with conveyor.
3. Strong penetrability and good and swift distribution of the heat
by letting the bottles rotate by itself and revolute in the rails
simultaneously in the infrared preheater.
4. High adjustability to enable the preheater to preheat preforms
in shapes by adjusting the light tube and the length of the
reflecting board in the preheating area, and eternal temperature in
the preheater with an automatic thermostatic apparatus.
5. High safeties with security automatic-locking apparatus in each
mechanical action, which will make the procedures turn into a state
of safety in case of a breakdown in certain procedure.
6. No contamination and low noise with the air cylinder to drive
the action instead of the oil pump.
7. Satisfaction with different atmospheric pressure for blowing and
mechanical action by dividing the blowing and action into three
parts in the air pressure diagram of the machine.
8. Strong clamping force with high pressure and double crank links
to lock the mold.
9. Two ways of operating: automatic and manual.
10. Safe, reliable, and unique design of the position of valve to
make the air pressure diagram of the machine easier to understand.
11. Low cost, high efficiency, easy operation, easy maintenance,
etc, with automatic technological process.
12. Contamination is avoided for the bottle body.
13. better chilling system.
14. Easy installation and starting
15. Low rejection rate: less than 0.2 percent.
|Production capacity||depend on bottle design||1200-1800pcs/h||3200-4200PCS/H|
|Bottle||Max volume of bottle||2000ML||2000ML|
|Main machine power||Electrial source power||380v3phase 50HZ||380v3phase 50HZ|
|Air source||LP air compressor||2.0m3/10MPa*1set|
|HP air compressor||1.2m3/min30kg||1.2m3/10MPa*1set|
|PLC||LG||South Korea||South Korea|
|HMI SCRENN||LG||South Korea||South Korea|